All FAQs (1653 total: showing 181-200)
- How can the CS320 be mounted if the 18356 leveling base is not used?
- Is it possible to read the output from a CS320 in a 4 to 20 mA form?
- On routine site visits, how can the calibration of the CS320 be checked?
- How often does the CS320 need to be recalibrated?
- What is the difference between a thermopile pyranometer and a silicon photocell pyranometer?
- How can an end user simulate a lightning strike to an SG000 or CS110?
- If a CH150 or PS150 is hooked up to both solar and ac power supplies, which power supply does the device use?
- Which software updates are free?
- Is the CSAT3A, CSAT3AH, CSAT3B, or CSAT3BH well suited for all environments?
- In terms of a network link interface, what is "bridge mode"?
- For the CPEC200, is the heater on the vortex intake controlled the same way as it was prior to the addition of the vortex intake?
- Has the vortex intake changed the way the pump for the CPEC200 works?
- With the new vortex intake, has the power drain changed for the pump module fan for the CPEC200?
- How is the intake pipe of the CPEC200 heated?
- Is the heater for the CPEC200 positioned along the intake pipe?
- What is PEEK, and why is it used in the CS526-L?
- What image/vector formats does MultiLogger Suite support?
- What are some common issues related to using thermopile instruments?
- What should a daily albedo graph look like?
- Using a CNR4-L, how should albedo data be handled at night when the reflected short-wave radiation is zero and the calculation ends up dividing by zero?
Previous
Next