AL200 ALERT & ALERT2 OS 6.08
Updated: 09-12-2025
- Make TBR accumulator 2 bytes all the time.
- fix issue where old tips in queue caused all tip history to be dumpt.
- fixed issue where P1 would report as GSR sometimes.
- fixed issue with periods of nondecodeable frames.
- fixed missing service request without sdi12debug.
- change modulation gain to a much more linear software model.
- allow for long SDI12 replies.
- prettier printout for multiline sensor replies.
- stopped stop_te from rarely dropping a time event.
- add resilience timeout to red LED state machine.
- add time event loss detection.
- address possible rare issue where red serial led stays on.
- Expanded SDI-12 interactive mode, added visibility for non measurement commands, added new command for full manual interaction.
- Extended sdi12 command length, 100 characters should be fine.
- Audio modulation voltage within 5% of selected setting, 15mv on 400mv, used code from AL200X for AL200, improved it and upgraded AL200X.
- Fixed tone for button press, power was not turned on.
- Dealt with carrier time = 0ms, check for zero and skip carrier state.
- found a lost event.
- Fix issue where RMC gap occurs and a factory reset is sent.