All FAQs (1869 total: showing 1781-1800)
- Is the observational data maintained in a CR10X if ac power is lost when data is written in the final storage area? Can the data of the final storage area be read by an internal program when ac power is restored?
- Can the CR10X communicate piezometer data easily with a Wonderware SCADA system for data display?
- Can the CR10X send data out the serial port to be parsed by another instrument? If so, is this automatic, programmed, or a response to a command from another instrument?
- How many data lines can a SM192 and a SM4M store using a simple program?
- How can the CNR1 be connected to a Bowen Ratio system?
- Does the CNR1 read out the values of incoming and reflected components separately, or does it just give the net value?
- How high above the ground should a net radiometer be placed?
- How many solar panels can be connected to a CH100 regulator? Can one 60 W solar panel and two 20 W solar panels be connected to the same regulator?
- What is the pin connection between USB and DB9 (RS-232) connectors?
- If an existing wind set is replaced with a wind monitor (05103-L, 05103-45-L, 05106-L, 05305-L), will more than the multiplier and offset have to be changed in the data logger program?
- How can the 229-L be calibrated?
- How are readings obtained from the 229-L?
- Is calibration of the 229-L available?
- If several 229-L probes begin returning very low positive and negative values for dT, what might be the cause?
- To use a multiplexer with a CR10X and very low sensor signals (1 mV and lower), should an AM25T or an AM16/32 be used? For which sensor signal voltages and sensor impedances can the AM25T and the AM16/32 be used?
- How should the AM25T be used?
- Can the AM25T be connected to an analog input channel on a device other than a data logger, such as a programmable logic controller (PLC)?
- What is the measurement resolution, in Hertz, of the AVW1, AVW4, or AVW100? Do these interfaces have any certifications of compliance?
- Does the AVW100 work with Edlog Instruction 28 or 131?
- How can the data logger build a text string and send it out the RS-232 port?
Previous
Next