All FAQs (1869 total: showing 1741-1760)
- How can a data table on the data logger be deleted using the simplepb.dll library?
- Can BMP5 Direct SDK software be used to interface/interact with a CR206X/CR211X datalogger via an RF416/RF411 connected to a PC serial port?
- If a facility has ordered the RTDAQ software but wants to start using it right away, can a copy of the software be downloaded from the Campbell Scientific website?
- If the installation disks for PC208W are lost, how can a replacement set be obtained?
- Does CRBasic have to be used to program a data logger? Does a menu-driven program generator exist for the data logger?
- The CR1000/CR3000 wiring panel shows four serial I/O ports on C1 to C8. Do these serial I/O ports provide the same functionality as the SDM-SIO4 module did on a CR10X or CR23X datalogger?
- Where can example programs be found?
- What is the 229-L heating element made of? In an acidic environment, such as copper mine tailings, would the sensor be expected to fail because of corrosion within five years?
- What is the optimum calibration frequency for a WindSonic?
- Is it possible for a WindSonic to operate in extreme conditions like snow, glacial temperatures, and freezing rain?
- Where is the interface cable for the WindSonic?
- Can vertical wind speed be measured by rotating the WindSonic 90 degrees?
- Can the WindSonic produce an output of 4 Hz or higher frequency?
- The WindSonic has the average 1 Hz output of 40 Hz block measurements. What does the 40 Hz block measurement mean?
- Is it possible to connect a sonic anemometer and an electronic compass to a smart data logger to give wind speed and direction on a non-fixed platform?
- If data is downloaded to a PC, the resultant “CR1000_Table1.dat” file is, for example, 150 kB in size. Is 150 kB necessarily its size on the CR1000? Is there any type of data compression being used?
- Can the CR1000 or CR3000 communicate over TCP/IP?
- Can the CR1000 measure 4 to 20 mA signals?
- What would it take to make the CR1000 wireless?
- Is a separate extension cable for a 05106-L available? The current cable is approximately 13 ft long, and it would be helpful to extend the cable another 20 ft.
Previous
Next