FAQs Frequently asked questions about our products and solutions

How is the baud rate set using PC400?

When using PC400 to connect to a data logger on an RS-232 port, the baud rate must be matched. This is done through the PC400 data logger settings.

This was helpful

FAQs Home

Similar FAQs

What is the default TCP/IP port that LoggerNet uses to communicate with PakBus data loggers?
How are PC400, LoggerNet, and LoggerNet Admin similar and different?
Are there any corrections to the raw data (not the average data) obtained by the CSAT3/3A/3AH?
How much does a typical system cost?
How many sensors can a data logger measure?
How do the PC200W, PC400, VisualWeather, and LoggerNet software options compare?
Is LoggerNet software needed to download the data from a data logger remotely?