FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

For the 107, 108, and 109 temperature sensors/probes, where within the white cylinder is the thermistor actually located?

The thermistor is located approximately 3 mm (0.125 in.) back from the probe tip.

This was helpful

FAQs Home

Similar FAQs

What is SDI-12?
If the sonic temperature is reading a couple degrees different from the IRGASON^® or EC150 temperature probe, is that a problem?
When trying to start LoggerNet, what might cause the "Unable to start program because the Campbell Scientific communications server is already running" message?
If the cable attached to a sensor is too short, can more cable be spliced to the existing cable to make it longer?
What type of field check can be done on a temperature sensor or a temperature and relative humidity sensor to determine if it is within the range of specified accuracy or if it requires calibration?
Is there a version of LoggerNet that will run on a Linux computer?
How can measurements be made using a 107, 108, or 109 temperature sensor/probe with a measurement device other than a Campbell Scientific data logger?