FAQs Frequently asked questions about our products and solutions

Is the Power Out (+12V terminal) on the PS100, PS150, or PS200 where the data logger should be connected for powering?

Yes. The G and 12V terminals on the charge regulator are used to connect the black and red wires that connect with the green connector, which provides power to the data logger.

This was helpful

FAQs Home

Similar FAQs

Are there any corrections to the raw data (not the average data) obtained by the CSAT3/3A/3AH?
Can an SP20 or SP20-PW solar panel be put in series to produce 40 W at peak output, similar to how the SP50-L can produce 100 W?
Using Short Cut, how can the average wind direction be calculated?
Is there a way to convert an Edlog program file to a CRBasic program file?
Can the CR6 have simultaneous communications (that is, Ethernet and USB) at the same time between two different computers?
What do “serial port open failed” and “permission denied” error messages mean?
What criteria should be used to select an antenna?