FAQs Frequently asked questions about our products and solutions

If the “pps” field returned by the GPS() instruction usually displays “990000,” what might be the cause?

Refer to the CRBasic Editor Help for the GPS() instruction. The system is working correctly. The data logger clock has been synchronized and is detecting a PPS line low to high transition within a 10 ms window before the start of the second.

This was helpful

FAQs Home

Similar FAQs

How much does a typical system cost?
The CR1000/CR3000 wiring panel shows four serial I/O ports on C1 to C8. Do these serial I/O ports provide the same functionality as the SDM-SIO4 module did on a CR10X or CR23X datalogger?
Is there a way to convert an Edlog program file to a CRBasic program file?
How many sensors can a data logger measure?
What do “serial port open failed” and “permission denied” error messages mean?
How can latitude and longitude data from a GPS16X-HVS receiver be recorded on a data logger and then parsed out?
If a computer does not have any serial ports, how can software (such as LoggerNet, PC400, PC200W, or Device Configuration Utility) talk to the data logger?