All FAQs (1639 total: showing 81-100)
- What are the multiplier and offset values used with the BaroVue™10?
- If the BaroVue™10 is not available for selection in the Short Cut program, how can it be added?
- Can the BaroVue™10 be used to measure pressure in an application at very high humidity without damaging the sensor?
- How often should the BaroVue™10 be factory calibrated?
- What is the warm-up time for the BaroVue™10?
- Is the BaroVue™10 a direct replacement for the CS106 and CS100?
- Does the BaroVue™10 need to be vented to the outside of an enclosure or building?
- Does the BaroVue™10 fit inside an ENC100 enclosure?
- What are the features and benefits of the BaroVue™10?
- Why are sites needed for a Wintersense network?
- Does the mast of the CM375 have any lightning protection?
- If duckbill anchors cannot be used to stabilize the CM375 in uneven, rocky terrain, what should be used instead?
- Can the base plate of the CM375 be fixed to the ground to improve stability, especially in rocky, mountainous areas?
- Can the mast and the guy cables of the CM375 support ice loading?
- Under what temperature conditions can the CM375 operate?
- What is the probable life expectancy of the CM375 mast?
- Is the CS241 recommended for use at the back or the front of the bifacial module?
- For the standard (non-NIST) version of the CS240 sensors, how does Campbell Scientific verify the ability of the sensors to measure and that the measurements made are calibrated to provide correct measurements?
- What are the differences between the different turbidity units used, such as NTU, FBU, FTU, and FNU?
- What is the difference between the backscatter measurement of the OBS-3+ and the side-scatter measurement of the ClariVue™10 sensor?
Previous
Next