All FAQs (1645 total: showing 101-120)
- What are the differences between the different turbidity units used, such as NTU, FBU, FTU, and FNU?
- What is the difference between the backscatter measurement of the OBS-3+ and the side-scatter measurement of the ClariVue™10 sensor?
- How can data from LoggerNet be added into the SCADA software OSIsoft PI?
- Why is NIST traceability beneficial for surface temperature sensors, such as the CS240, the 110PV, and the CS240DM?
- How does the CH201 compare with the 18529 Morningstar SunSaver-10 Regulator?
- Can the CH201 be connected to two 12 A sources, or does the total from the two sources have to be equivalent to 12 A?
- If a CH201 is connected to both a solar panel and an AC/DC power convert, which power supply does the device use?
- How quickly can measurements be attained using the ClimaVue™50?
- Are the traditional methods of using RTD to measure the back-of-module temperature not used with the CS240 and CS240DM because these methods may cause hot spots?
- Can multiple instances of Campbell Scientific SURVEYOR be run on a PC at the same time?
- How tight do the wing-nuts on the CM226 integrated mounting stand need to be tightened to secure the solar sensor?
- Can the SG000 determine the exact distance to a lightning strike?
- When selecting a calibration service for a pyranometer, how do the services differ and what is the importance of ISO 9060?
- What are some distinguishing features of the MetSens compact weather sensors?
- Can the CSAT3BH heaters be controlled manually?
- What happens to the data when the CSAT3BH heaters are on?
- How often does the LevelVue™B10 need to be serviced?
- For the LevelVue™B10, can I use the temperature value as ambient air temperature?
- To get accurate readings with the LevelVue™B10, is it necessary to know the temperature of the water?
- Is it necessary to use a stilling well with the LevelVue™B10?
Previous
Next