FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

All FAQs (1770 total: showing 1401-1420)

Can converters to 18 Vac and 12 Vdc be located within an ENC16/18 without affecting the data logger or data?
Can 120 Vac be brought into the ENC16/18?
How many mounting accessories should be ordered for each major device inside an enclosure?
What are the weight and internal dimensions of the ENC16/18?
What are the weight and internal dimensions of the ENC14/16?
Is a fiberglass enclosure suitable for an installation in a very cold location monitoring corrosion?
If the copper ground terminals attached to the bottom of an enclosure are oxidized and corroded, how can they be replaced?
What are the distances, center-to-center, of the mounting holes in the back of the ENC14/16?
What are the weight and internal dimensions of the ENC12/14?
If the PVC fittings at the bottom of the enclosure have too small an inner diameter to accommodate all the cables passing through, is there a way to remove the PVC fittings?
What is the preferred method for punching a clean hole through the bottom of an enclosure?
Can just the backplate of an enclosure be purchased?
What are the weight and internal dimensions of the ENC10/12?
Does the enclosure have a mounting bracket inside to mount the datalogger?
What are the part numbers to order replacement dowels for measuring fuel temperature and moisture?
How often should the fuel temperature and moisture dowels be replaced?
Where is there a picture with part numbers for the fuel moisture sensor, fuel temperature stick, temperature probe, and mounting stake?
Is it possible to make a portable system that can use a TDR100, a data logger, and a TDR probe to sample on command via a switch?
How can both a TDR100 and an SDM-IO16 be connected to a single CR1000 or CR800?
Is it possible to connect more than one TDR100 to a data logger using different SDM addresses?

Previous Next