All FAQs (1645 total: showing 1301-1320)
- What are the distances, center-to-center, of the mounting holes in the back of the ENC14/16?
- If the PVC fittings at the bottom of the enclosure have too small an inner diameter to accommodate all the cables passing through, is there a way to remove the PVC fittings?
- What is the preferred method for punching a clean hole through the bottom of an enclosure?
- Can just the backplate of an enclosure be purchased?
- Does the enclosure have a mounting bracket inside to mount the datalogger?
- How often should the fuel temperature and moisture dowels be replaced?
- Where is there a picture with part numbers for the fuel moisture sensor, fuel temperature stick, temperature probe, and mounting stake?
- Is it possible to make a portable system that can use a TDR100, a data logger, and a TDR probe to sample on command via a switch?
- How can both a TDR100 and an SDM-IO16 be connected to a single CR1000 or CR800?
- Is it possible to connect more than one TDR100 to a data logger using different SDM addresses?
- How can data from a TDR100 be downloaded to a laptop when only a USB port is available?
- What help is available for using the TDR100 for a slope stability/rock mass deformation measurement application?
- Is it possible to export the time-series data logged from a TDR100 to a computer?
- Can Short Cut for Windows write data logger code for the TDR100?
- Which soil water content probes are available for the TDR100?
- What items are needed to set up a TDR100 Data Acquisition System?
- What is the bending limit for the cable on the 110PV-L?
- Using Short Cut, is the 110PV-L configured as a half bridge, 4-wire? If so, how is the resistance calculated, and what needs to be done so that the correct temperature range will be produced?
- What would indicate there is an issue with a 110PV-L?
- How can a data logger be programmed to use a 110PV-L?
Previous
Next