FAQs Frequently asked questions about our products and solutions

Ask a Question Ask a Question

All FAQs (1645 total: showing 781-800)

What is PakBus encryption?
Can files on a PakBus data logger be hidden?
Which data logger files can be encrypted?
How effective are pass-code lockouts for CRBasic PakBus data loggers?
How can a data logger be made more secure?
Is there a module to read a group of fine-wire thermocouples?
Can Campbell Scientific fine-wire thermocouples measure the temperature of a 50 µm by 50 µm flat surface?
Is it possible to measure the absolute temperature with an accuracy of 0.01°C using the FW05? Or do the thermocouple output error and the thermocouple voltage error inhibit such accuracies?
How is sensible heat flux measured using a CSAT3/3A/3H and an FW05?
To measure sensible heat flux using the eddy-covariance technique, which fine-wire thermocouple should be used?
How can the pulse output of a 03101-L be converted to a 4 to 20 mA output?
If a cup breaks off the 03101-L, can the cup be replaced, or is a new sensor needed?
What might cause a 03101-L to produce a signal that is not high enough to be registered by the magnetic pickup?
How is the 03101-L, with its offset fitting and strain relief, mounted to the conversion kit?
Can the 03101-L be installed in a position that is tilted to the horizontal?
Is a device, such as the COM320, necessary for initiating a call when the measured parameters fall out of a specified range?
Can dual communication modes be run on a single CR1000 using a COM320 and an NL120?
Can a CWS900-series interface make thermocouple measurements?
How many CWS900-series interfaces can be put inside an enclosure, such as the ENC10/12, without causing interference issues?
Does the use of a CWS900-series interface require direct line-of-sight?

Previous Next