All FAQs (1645 total: showing 1481-1500)
- Can the CR800 be programmed through either a mountable or portable keyboard display?
- Is there an Ethernet module available for the CR800 or CR850?
- What is the maximum current that the control port of a CR800, CR850, or CR1000 can source without causing damage?
- Does the CR800 or CR850 work with a 2 kHz (maximum) burst mode for the VoltDiff() instruction like the CR1000 does?
- Can the battery on the CR800 or CR850 be changed by the user?
- How can several SDI-12 instruments be wired to a single data logger terminal?
- Can a CR800 wiring panel be used on a data logger other than the original data logger?
- What is the maximum supply voltage of a CR800 or CR850 without damaging the data logger?
- Why do the example programs for the WXT520 use a scan rate of 5 seconds?
- Why do the values from the WXT520 seem to be out of order?
- If the wind speed on the WXT520 constantly reads 0, what should be done?
- Is LoggerNet software needed to download the data from a data logger remotely?
- Can the constants located within the ConstTable/EndConstTable instructions be edited?
- Can the display timeout and contrast be programmed by the CRBasic Editor?
- Can the CR800, CR850, CR1000, or CR3000 upload to an FTP site on scheduled intervals?
- Is it possible to connect the CR800, CR850, CR1000, or CR3000 to a SCADA system through a Modbus RS-485 protocol?
- How can the CR800, CR850, CR1000, or CR3000 be configured as a Modbus RTU server?
- Can the LoggerNet software used for a CR10X be used with a CR850 or CR800?
- Is it possible to overwrite an existing array using a CR850?
- Can the NL201 be put into bridge mode via the settings of a CR800 or CR850?
Previous
Next